2003 seville sts, ultastart g11-xr, xk01

have a Ultra Start G11-XR with DEI xk01 bypass to go into a 2003 Cadillac seville STS. Unable to find a reliable wiring diagram. If anyone has a good source please let me know. thanks micky

2003 Seville Sts 12 Volts-Orange + Ignition Harness This is a low current 12V source that should not be used to drive any high current positive circuits. Second 12 Volts-ORANGE / Black + Ignition Harness Starter-Yellow + Ignition Harness Second Starter-N/A Ignition-Pink + Ignition Harness Second Ignition-White + Ignition Harness Third Ignition-N/A Accessory-Orange + Ignition Harness Second Accessory-Brown + Ignition Harness Third Accessory-N/A The ignition harness is accessed by removing, but not unplugging the radio. Keysense-N/A Data Bus-N/A Can Bus High-N/A Can Bus Low-N/A Can Bus Sw-Purple Data Data link connector under driver dash, pin 2 Power Lock-RED / Black - driver lock switch in door Power Unlock-ORANGE / Black - driver lock switch in door Parking Lights (-)-BROWN / White - DIM module The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module. Parking Lights (+)-Do Not Use + Trunk/Hatch Release-Light Blue - RIM module The RIM module is located behind the rear seat in the lower corner on the passenger side. Factory Alarm Arm-arms on lock Factory Alarm Disarm-Light Green - driver door module in door The driver door module is located above the speaker in the driver door. Can also use Directed interface module. Disarm No Unlock-See Factory Alarm Disarm Tachometer-PURPLE / White AC ign. coil on top of motor Brake Wire-White + low in driver kick Horn Trigger-Black - DIM module The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module. Missing anything?

2nd ORANGE / black 12v but why do the options turn on with switch whn under remote start, then? power is available and bypass is sending signals on data wire. ???

2003 seville sts with ultastart g11-xr and a xk01 bypass module. supposed to trigger defrost and heated seats when below 30 degrees. Does not work. If car is running by RS you can turn on both (power to switches is availble) but does not automatically turn on. Everything else works fine (heater, lights, remote start, security enable/disable). Any ideas? Supposed to have amdl 6.0 flashed on xk01....