not very sharp with fine tunning

This just went straight into my printer thank you so much. My new question is that i just noticed that one of my subs is only receiving voice signals and no bass and i read that this can only be bridged to a 3 channel so 1 sub and 2 component speakers. Is there any way i can run both subs on this amp? one of them is already bridge and sounds awesome i just want the other one to get bass not voice. THank you.

(2) 4ohm dual VC. option 2 Wire as in option 2 to your bridgeable channels. The other 2 can be used to power your front stage. I assumed this is what you were doing. My bad for not asking.

Thank you so much i traded my amp with my uncle for a lazar vibe 251 the specs are Lanzar VIBE-251 2-Channel Vibe Series High Power MOSFET Amplifier - 1600 Watt Amplifier - 1600 Watt: 2 x 250 Watts RMS at 4 Ohms 2 x 800 Watts Max at 4 Ohms 1 x 1000 Watts Max at 4 Ohms Bridged 2 x 450 Watts at 2 Ohms What is your honest personal opinion about this one?

well if you take their max 1000 watts at 4ohm bridge. Which is how you would run it and cut it in half, thats about the rms it should make 500rms or a bit less knowing lanzar. It should pair with your subs nicely.