how should i wire these subs to this amp?

in my amp ratings it says i can run 4 ohm 2x600 ?/?  why cant i run that?

With all the power i wont blow subs settign gain to speaker clipping?

What many rms would i be running at 8 ohms?

so yea think i should  just hook it up briged then  and run it like idots diagram  And then  set gains proper

you can wire only one voice coil of a dual voice coil woofer, the power handling wil be cut to around 75 percent of the 500 watts that they handle with both coils being used.  This will still have you in the same boat as the 2000 watts into the 4 ohm mono load.

On paper the amp wil produce 300 watts per channel into an 8 ohm stereo load. 

If it were my amp and my speakers, it would be wired 4 ohm mono.  But if you are not confident in your ability to determine a safe (for your speakers) listening level, that may not work for you.

k you guys told me to hook my l5 dual vioce coils  to my amp heres the way i hooked them up

NOw ... You guys know amp amp is a dual monoblock amp right??   is this still the way i should hook them up to dual monoblock amp?

yes

Even with a dual mono amp?  its like haveing 2 monoblock amps   all in one..