2007 buick lucerne

12 V - 14 ga. RED / White at BCM above Passengers kick pannel in Black connector. Ignition - 18 ga. Pink at same in green connector ACC - 18 ga. brown at same in green connector Starter - Connect accessory to ignition through relay to prevent vehicle from starting. Connect ignition PINK to terminals 87 and 86. Connect accsesory BROWN to terminal 30. Connect armed (-) out of alarm to 85. Horn - 18 ga. Tan at same in brown connector. Lights (-) 18 ga. Gray/Blue at interior light switch assembly on left side of dash. Door 1 - 18 ga. Gray/Black(-) in drivers door. Door 2 - 18 ga. Tan/White(-) in pass door. Door 3 - 18 ga. Lt. Blue/Black(-) at B.C.M. in Pink connector. Door 4 - 18 ga. Pink/Black(-) at same. Trunk Trigger - 18 ga. ORANGE / Gray(-) at same Hood Pin - 18 ga. Pink/Black in Black connector. Interior Lights - 18 ga. Pink/Black(-) at same in white connector, or 16 ga. Gray/Black(+) in Pink connector. Trunk Release - 18 ga. Lt. Blue(-) at same in White connector, motor wire is Tan/White(+) in Gray connector. Lock (switch) - MPX from door switches Unlock (switch) same Disarm (key) - In drivers door, also unlocks doors on second pulse. Arm Input - 14 ga. Gray (M) at either side rear running board, wire is for rear doors only. Disarm Input 1 - 14 ga. Tan (M) in drivers door only. Disarm Input 2 - 14 ga. Tan (M) at same as arm input alarmwizard

perfect! thanks! anything on the speed signal wire for this car???~~~wael~~~

VSS: Violet / Black @ PCM inside air cleaner plug C1 pin #22 or Throttle actuator control module on throttle boby assembly pin #4This information is provided only as a reference.

All circuits should be verified with a digital multi-meter prior to making any connections.

perfect! thanks guys~~~wael~~~