new clifford matrix 1.2 will not arm?

Home / the12volt's Install Bay / Car Security and Convenience / new clifford matrix 1.2 will not arm? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

dirtysneaker

Member - Posts: 5

Joined: May 24, 2011

Location: California, United States

Posted: May 28, 2011 at 7:09 PM / IP Logged

tony_g wrote:

the +12v on H3/1 is for the system to allow you to get into programming mode and adjust settings for however you want them. the old magicar brain was by the sounds of it a vehicle security system so would sound a siren/horn when a door or trunk would be opened but the clifford brain is purely for r/s and keyless entry, even though it monitors door and ignition inputs it does not have the output to run a siren and is not programmed to operate like a security system when an access point or ignition is violated. you could probably get it to sound a siren when armed and an entry point is opened but that would involve some relays patience and clever thinking but do-able

That would explaina lot. it is tied to my friends stock alarm so that is why it works that way on his vehicle.

I am going to do some fancing wiring then to get this to work like an alarm.

Thank You for all your Help everyone new clifford matrix 1.2 will not arm? - Page 2 -- posted image.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

new clifford matrix 1.2 will not arm?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.