1998 honda accord ex rs

need your help guys. i installed a compustar rs (cm5200) and i use the idatalink ads-tb as my bypass. all my keyless  wirings are good but i cant remote start the car. i program the bypass and its good. when i try to insert the key at the key barrel and remote start the car and its working. what do you think is the problem? i try to use a different unit and bypass and still cant remote start the car.

do i need to connect the disarm wire (blue) to the rs unit? where can i get that wire other than the power window module?

where can i connect the pink wire (ignition input) of the ads-tb bypass to the vehicle?

where can i find the trunk release wire?

thanks in advance

hi! i check my bypass wiring and it looks good but im not sure the pink wire (ignition input) of the ads-tb. where should i connect that wire? in the ignition wire (BLACK / YELLOW) of the accord?

if i dont connect the disarm wire of the rs unit to the disarm wire (blue) , can i still remote start the car?

thanks

hi! can i connect together the rearm wire and lock wire of the rs unit and attach it to the lock wire of the vehicle (same as the disarm and unlock)? so that i dont need to open the drivers door module to get the blu disarm wire.

thanks

ok..

this is my ads-tb  bypass wiring

GREEN/ red ----- blue wire at the key barrel

gray/red ------ red wire (ecm side)

gray / YELLOW------- red wire(connector side)

pink---------- BLACK / YELLOW ignition wire at tge ignition harness