chevy suburban 2011

I need the wiring information for alarm and remote start.

Thanks

Remote Start Battery RED / BLACK(+)VEHICLE INTERIOR FUSE BOX Ignition 1 PINK(+)IGNITION SWITCH HARNESS Ignition 2 WHITE(+)IGNITION SWITCH HARNESS Accessory 1 BROWN OR YELLOW(+)IGNITION SWITCH HARNESS Starter 1 YELLOW/BLACK(+)AT MODULE UNDER HOOD BEHIND DRIVER HEADLIGHT***Not for remote start Starter 2 WHITE(+)IGNITION SWITCH HARNESS*** USE A 1.3K OHM RESISTOR FOR STARTER Anti-Theft Type -GM PASSKEY III® ANTI-THEFT SYSTEM Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER Key Sense PINK/BLACK OR PINK(+)IGNITION SWITCH HARNESS Tachometer WHITE(-)AT IGNITION COIL Crankshaft Sensor WHITE/ BLACK(AC)AT ECM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD **PLUG C2 - PIN #68 Camshaft Sensor DARK BLUE/WHITE(AC)AT ECM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD PLUG C2 - PIN #64 Speed Sense YELLOW/BLACK(AC)AT ECM MODULE UNDER HOOD ON DRIVER FENDER ** BLACK PLUG PIN #57 Parking Lights LIGHT BLUE(-)AT BCM MODULE UNDER DRIVER DASH Brake Lights LIGHT BLUE/WHITE(+)AT SWITCH ABOVE BRAKE PEDAL Reverse Lights DARK BLUE(+)AT BCM MODULE UNDER DRIVER DASH Horn TAN(-)AT BCM MODULE UNDER DRIVER DASH

Alarm All Door TriggerGRAY/BLACK(+)AT BCM MODULE UNDER DRIVER SIDE DASH** SOME VEHICLES MAY NOT BE EQUIPPED WITH THIS LIGHT, IN THIS CASE YOU MUST USE ALL FOUR DOOR TRIGGERS AND DIODE ISOLATE EACH WIRE Domelight Supervision GRAY(+)AT BCM MODULE UNDER DRIVER DASH LF LatchGRAY/BLACK(-)AT MODULE IN DRIVER DOOR** MAY BE BROWN ON SOME MODELS RF LatchTAN/WHITE(-)AT MODULE IN PASSENGER DOOR **MAY BE BLACK/ WHITE ON SOME MODELS LR LatchLIGHT BLUE/BLACK(-)AT BCM MODULE UNDER DRIVER DASH ** PINK PLUG PIN #15 RR LatchLIGHT GREEN/ BLACK(-)AT BCM MODULE UNDER DRIVER DASH **PINK PLUG PIN #14 Hood TriggerPINK/BLACK(-)AT BCM MODULE UNDER DRIVER DASH ** BLACK PLUG PIN #17, NOT ON ALL MODELS Alarm DisarmLIGHT GREEN(-)AT MODULE IN DRIVERS DOOR Parking LightsLIGHT BLUE(-)AT BCM MODULE UNDER DRIVER DASH Data BusDARK GREEN(-)AT OBD 2 PLUG

Forgot to add for Starter Kill use only starter 1 yellow/black(+) wire