volvo xc90 rs problem

hi guys! i installed a rs for 2005 volvo x90. i use the compustar cm6200 module and idatalink ads-al as my bypass. i connect everything but i couldn't remote start the car. the keyless is working good and if i leave the key  in the key barrel, the rs working. on the keysense wire i use the rs BROWN / white wire and change the jumper to positive polarity. what wire should i use to connect the vehicle keysense wire?  is it the r/s ign2 wire or the keysense wire?

thanks

Did you follow the Type 1 wiring diagram in the iDatlink install guide #7668, including the ADS White and WHITE/ Black wires doing the "keywrap" with a spare key as shown?

The CM6000 BROWN / White wire is an input wire, not an output.  You will need to wire up a relay as follows for Keysense(+).

Relay Pin 85 to CM6000 CN3 Pin 11, Black GWR

If you are also using CN3 Pin 11 for the ADS bypass module GWR, diode isolate.  Or, if you have

@kreg, thanks man. i will try that one. how about the accessory wire from the vehicle. can i use both of them (acc1 and acc2)?

@tedmond, i already did that one. base on the wire diagram the keysense wire is required. what i did is that i use the black and BLACK/ white wire of the idatalink ads-al bypass to wrap the valet key. what i dont did is that, i never realize that the vehicle keysense is an output. i will try to rewire the keysense wire.

thanks