the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2002 Dodge Durango Alarm/Remote Start, Stereo Wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
Wm2k3 
Member - Posts: 7
Member spacespace
Joined: May 05, 2003
Location: Canada
Posted: May 05, 2003 at 9:21 PM / IP Logged  

anyone??

I've noticed the "notes" part on the other wiring diag, I need those aswell to by pass the factory alarm, and add the keyless entry.  Thanks

Patel 
Copper - Posts: 86
Copper spacespace
Joined: October 20, 2002
Location: Canada
Posted: May 06, 2003 at 12:29 PM / IP Logged  
|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |
|              12V|pnk/blk & RED / lt blu|+ |ignition harness            |
|          STARTER|yellow              |+ |ignition harness            |
|        IGNITION|blue               |+ |ignition harness            |
| SECOND IGNITION|GREEN/ red    (18 ga)|+ |ignition harness            |
|        ACCESSORY|BLACK/ orange        |+ |ignition harness            |
| SECOND ACCESSORY|green               |+ |ignition harness            |
|       POWER LOCK|WHITE/ green        |*1 |conn. 2, pin 10 @ CTM *2    |
|     POWER UNLOCK|same wire           |   |                            |
|       LOCK MOTOR|ORANGE / black        |   |conn. 2, pin 4 @ CTM *2     |
|     UNLOCK MOTOR|blue               |   |conn. 2, pin 6 @ CTM *2     |
|    DISARM DEFEAT|pink/black          |   |conn. 2, pin 5 @ CTM *2     |
| PARKING LIGHTS +|BLACK / YELLOW        |   |headlight switch            |
| PARKING LIGHTS -|RED / yellow          |   |conn. 1, pin 4 @ CTM *2     |
|       HEADLIGHTS|lt. GREEN/ orange    |- |headlight switch            |
|     DOOR TRIGGER|*3                  |- |CTM *2                      |
| DOME SUPERVISION|use door trigger    |   |                            |
| TRUNK/HATCH PIN|tan/black           |- |conn. 2, pin 7 @ CTM *2     |
| FCTRY ALARM ARM|lt. GREEN/ orange    |*4 |conn. 2, pin 14 @ CTM *2    |
|FCTRY ALRM DISARM|same wire           |   |                            |
|       TACHOMETER|*5                  |   |ignition coil               |
|      SPEED SENSE|WHITE/ orange or blue|   |conn. 2, pin 27 @ PCM *6    |
|       BRAKE WIRE|WHITE/ tan           |+ |brake pedal switch          |
|     HORN TRIGGER|BLACK/ red           |- |steering column or CTM *2   |
|           WIPERS|purple(L), RED / gry(H|+ |steering column             |
| LF WINDOW UP/DN|lt. blue - white    |A |driver window switch        |
| RF WINDOW UP/DN|brn/wht - pur/wht   |A |driver kick panel           |
| LR WINDOW UP/DN|blu/wht - RED / blk   |A |driver kick panel           |
| RR WINDOW UP/DN|gry/blk - grn/wht   |A |driver kick panel           |
|        RADIO 12V|pink               |+ |radio                      |
|     RADIO GROUND|black               |- |radio                      |
|     RADIO SWITCH|RED / white           |+ |radio                      |
| RADIO ILLUMINATE|white               |+ |radio                      |
|       LF SPEAKER|lt grn/pu-lt grn/grn|   |radio                      |
|       RF SPEAKER|lt blu/pu-lt blu/blk|   |radio                      |
|       LR SPEAKER|wht/red - wht/blk   |   |radio                      |
|       RR SPEAKER|tan/pur - tan/blk   |   |radio                      |
Notes:
NOTE: Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. *1 Lock is negative trigger thru a 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays. *2 The Central Timer Module is in the driver kick panel. *3 The driver door trigger is tan in connector 2, pin 15. The passenger door trigger (and rears) is tan/red in connector 2, pin 13. Use both and diode isolate each. See directfax document #1076 for wiring information. *4 Arm is negative trigger thru a 644 ohm resistor. Disarm is negative trigger thru a 1565 ohm resistor. MUST use relays. This wire will also lock the doors, and it will unlock with a double pulse. *5 On the 5.9L models use BLACK/ gray at the ignition coil. The 4.7L models have an ignition coil for each cylinder, use the wires that is NOT GREEN/ orange at one of the coils. *6 The Powertrain Control Module is on the passenger fender.
Wm2k3 
Member - Posts: 7
Member spacespace
Joined: May 05, 2003
Location: Canada
Posted: May 06, 2003 at 8:48 PM / IP Logged  

Use DEI part number 555C or 555U

what is that and where do i get it???


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, May 4, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer