2012 honda civic drone dr1000

hello guys! i installed a cm6200 module and fortin evo all as my bypass into a 2012 honda civic. after a month the guy came back to me to install a drobe dr-1000 unit. i use type 3 connection for the drone dr 1000. my problem now is that if i use the iphone to start the car, the car will start but once i open the door , the car will alarm and the car will shutdown. if i use the compustar remote, it work perfectly. i connected the drone unlock wire into the vehicle lock wire. i also connect the cm6200 disarm wire into the drone unlock/ disarm wire but the problem is if i start the car, it will unlock the car.tianot

I had that dr-1000 install in my 2012 highlander. But as I remember these were the only wire connect is 12 v and ground to the drone and the black 4 pin from the drone to the black port of the module ( the port where you use to update the unit) and that was it. I think you have to go thru the module unit first so it can know what the drone want and did.My setup is cm6200 w blade al bypass. I can start, lock and unlock just fine and that was my first ever install compustar remote start. I don't know much about it yet but these guys in here know and will explain to you more.

You must use type 2 on this one because you conect to (< size=1>< size=1>Firstech Control Module) like the instalation manual said. try that you will see.