prostart toyota corolla 2006

Please read and digest pages 27 and 28 of the install guide.

R/S 2x12volt constant Red → White 12volt constant ignition Purple Starter → Red Starter wire Yellow Ignition → BLACK/ White Wire Green (5th relay) –> BLACK / YELLOW Wire Orange Accessories → blue/red wire Black ground → Ground bolt in chassis Grey hoot switch → Hood Orange Brake switch (+) → GREEN / WHITE brake wire (near brake/cylinder) Yellow Parking light output → Green wire in the wire harness White (GWR) → blue/white wire on PKALL (haven't hooked up PKALL) Gray – (Negative door input) → Red Door trigger wire So I have gotten the parking light to be on now. Also the light on the antenna flashes rapidly but when I open the door, it stops. When I plugged in the power, the unit clicked 4 times. I can get into programming mode with both the hood pin and also through PAB. I however, cannot start the car, no cranks or anything. I also did try grounding the purple wire from the 12 pin. I also tested voltage from the wires and also the pins and got 12+ volts.

I'm also just tying my cables in and using electrical tape to secure it. When I know it works, I'll solder it in, incase I made a mistake somewehre

Anyways, I GOT IT TO WORK!!! The problem was actually the antenna itself. Replaced the antenna and it starts up like a charm Thanks alot for your help, that helped alot too!

Well I had a problem? maybe arise. If I lock my car door from inside the car, my remote starter doesn't nkow it's locked. When I try to unlock it, it doesn't work. I have to manually unlock it first before I can lock with the remote starter. Also, when I manually lock the door, the antenna blinks rapidly like my locks are unlocked. Any clue what the problem is?

Also, if I lock the doors while the door is open, this problem arises. If I close the door and lock the doors manually (sitting inside), I can still lock and unlock with the remote starter.

Anyone?? I'm thinking because the door trigger grounds when the door is open... thus turning off the antenna, perhaps I need a relay like the bulldogsecurity wiring diagrams suggest. http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp Do I do this? http://www.bulldogsecurity.com/bdnew/newsite/pictures/pdfs/775%20for%20NEGATIVE%20DOMELIGHT%20SUPERVISION.pdf Any help would be greatly appreciated. I would like this done before the weather dips too cold.