strange noise noticed at idle w remt strt

HI guys, Just wanted to say thanks to all of the replies I received regarding my remote start / transponder install. I have one more question though. When I remote start my vehicle, I hear this strange sound that sounds like a loose heat shield on the cat or exhaust or a loose piece inside an exhaust component or possibly the starter getting not getting enough power. However, the sound is non-existent when I physically start my vehicle with the key itself. Anyone have an idea of what it might be? And what is the fix? Again, I have a 2000 Nissan 2.4 Ltr, chip key, Autopage RS 720 remote starter installed.

Anti grind not working on second starter? Second starter incorrectly wired?

That's what I'm thinking. It sounds like your starter is continuing to crank after starting. Do you have tach hooked up and programmed or what engine sensing are you using?Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205

No tach or anti-grind connected, will be doing that tomorrow morning. Again, im a noob at this

How did you connect the 2nd starter? And please don't tell me you just jumpered off the main starter...Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205

A 2nd starter was added using a relay.

I quote "No tach or anti-grind connected" and there's your answer, also possibly starters 1 and 2 wired in the wrong order. Leaving it in tach mode without programming will cause the R/S to run for up to 15 seconds with the starter engaged.

Here is what I have followed in connecting the 2nd starter(see below). Point me in the right direction if this is wrong http://www.commandocaralarms.com/2ndstarterwire.asp

BLACK / YELLOW starter one. BLACK/ blue starter 2.

You were told this plus conflicting colours in a previous thread, did you even test as advised or just do the amateur trick of just blindly connecting without testing?