the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2000-2003 Ford Taurus Remote Start w/Keyless Pictorial


Post ReplyPost New Topic
< Prev Topic Next Topic >
hemi93 
Member - Posts: 2
Member spacespace
Joined: January 09, 2015
Location: Iowa, United States
Posted: January 11, 2015 at 10:41 AM / IP Logged  
Alright thanks for helping me with that. I just had a few more wires i had questions about.. On the Remote Start Harness (H3) pin 1 is a neutral safety switch input. Where would that get connected too. And is it possible to hook up the rear defogger on this install. Im assumming ill need a relay to do it. Its pin 5 on the (H3) harness and on my db-all2 what is the RAP Off get connected to?
kreg357 
Platinum - Posts: 7,802
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Electrical Theory. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 30, 2009
Location: Pennsylvania, United States
Posted: January 11, 2015 at 3:38 PM / IP Logged  

On your Viper 4205, the Neutral Safety wire is connected to Chassis Ground.  This is typical for any vehicle with an automatic trans.

Here is some info from earlier on this Pictorial from forum member e129745 ( Patrick ) concerning the rear defroster :

Update to Rear Window Defogger on my 2002 Taurus Sedan;
Dash momentary button provides (-) to GEM DrkBlue/Orange pin6 of 20pin connector C201b (1 of 3 GEM connectors). The GEM
continues to offer timed (-) to Pin 86 coil of Defogger Relay located in CJB (Central Junction Box) Therefore H2/3 (-) 200mA can be
programed opt.3 Pulse which should operate Defogger without adding a relay and will also light Dash Defogger LED indicator,
timing out with factory timer. Cool!

His was a 2002 Taurus so test and verify.  If it tests properly, no relay is needed.

As for the DB-ALL2's RAP connection, follow the DB-ALL2's install guide / diagram.  Here is the Driver's Door Trigger wire info :

ReadyRemote
Driver Door Trigger       Yellow/Black   @ GEM 26 Pin Plug

Soldering is fun!
Page of 6

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, October 6, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer