another viper 5901 rs wiring issue tundra

Well, still no go.. the door locks work fine but the remote start doesnt. It only has a keyless entry and it flashes 8 times and says error when I hit the button. I have the Neutral Safety Switch ON, and the doors locked and armed. SO... I have the

• H2/10 dark blue as ((Keysense)
• H2/9 Violet/white as (Tachometer)
• H2/18 BLACK/ white (Neutral safety) to ground... since we dont have a normal switch that was the recomended way to hook it up... thoughts?
• H2/16 Blue/white for (Rear defog)
• H2/17 brown (brake pedal wire)
• H2/8 Brown /black (Horn trigger) horn honks just fyi

Im assuming its in the H2 harness and that its some input output wire and not the others since i only have a few hooked up... on the other sections... power, ground, hood pin,door trigger, parklights, and lock harness all work fine... Any thoughts?]:-)

Is the Neutral Safety Switch ( two pin harness ) plugged in and the switch set to ON?Soldering is fun!

yep, switched to on and plugged in 8-)]:-)

OMG FINALLY fixed it, from every thing I read this stupid things manual 10 times and every thing I found was wrong on how to fix the 7 flash error code... A little more research and you tube help got it finally fixed! it was in Manual trans mode, and the program in the instructions were totally off, I posted the way to fix it here and a link just in case! Super thanks all for the help! what a feelin to hear it start and run AND have the door locks work... 8-) and a link to the page https://www.youtube.com/watch?v=wsSorAf88nw oh heres the truck half way done just out of paint... Next up new stereo...]:-)

oh whoops forgot the truck pic 8-)]:-)