subwoofer wiring kicker compr

I have two compr kicker subs that have a switch that you can choose between 2 ohm and 8 ohm. On the box it says they are dulvoice 4 ohm. I have a kicker amp zx500.1 how can I wire the subs to run at 2ohm. The amp is stable at 2ohm.is there away to wire them so the amp has a 2ohm load and the speakers are at 2ohm. Thanks

If you wire both coils in Parallel, you get 2-ohms. You would wire the + from the amp, to both + terminals, then wire the - from the amp to both - terminals. You can use the amp at 8ohms too, and wire both coils in series. + terminal from amp , to + on 1st coil, - from 1st coil to + on second coil, - from second coil to amps - terminal. Parallel: +)------>(C1+)--->(C2+) -)------>(C2-)--->(C2-) 2OHM LOAD Series: +)----->(C1+)(C1-)-->\ -)<-----(C2-)(C2+)<--/ 8OHM LOAD C1 = Voice Coil 1 C2 = Voice Coil 2

^^^^^^^^^ With the drivers you have, your choices are 1 ohm, 4 ohm or 16 ohm. The only way you can achieve a 2 ohm load is to use only one coil of each speaker. This will reduce the speakers power handling by about 30%. I would not do it. Run them at a 4 ohm load and everything will last longer.

Click the Subwoofer Wiring Options link in the left column.Support the12volt.com