idatalink, 5706 wire confimation

That's ok

Great   Thank you

Ok, so all my connections are made securely and soldered and wrapped. Now I should be at the fun part but it seems I may be missing something in the datalink programming. It should be simple I'd think. After plugging in the 15a fuse on the 5706p red wire I got a single blinking green from the datalink unit. I thought this was the single green for data mode I was looking for. I even checked and got it to blink twice for hardwire then back to data mode. For the actual module program procedure I never got the 2 second solid green in step 3 Page 9 says flashing green means: false ground when running from remote start

Try it this way.

1.  Perform the Factory Reset procedure shown on Page 9, but stop after Step 5.

2.  After the LED goes Red for two seconds, it goes off for several seconds and the starts doing the single Green Blink.     That is the 1X blink for Data Mode.  Press the programming button and hold it, the LED will go solid Green for two     seconds and then out.  Release the button.  You are now programmed for Data Mode and it's locked in.3.  Reconnect the rest of the ADS AL-CA harnesses.4.  Continue on with the Module programming on Page 8, by inserting a Master Ignition key into the ignition switch and      turning it to the ON position.  Finish through to Step 6.

Hopefully the LED responds correctly at Step 3.  If it looks good, try the door locks and trunk release.  Next try a remote

start.

Soldering is fun!

Kreg. I am dumb. I somehow missed the simple step 2 where you hold the bottom down to lock it in. It is set properly now. After that I was able successfully program the 5706 remote start to automatic trans and the flex relay to acc 2 EVERYTHING WORKS PERFECTLY!!!!!! Door locks, trunk, interior light. Parking light and remote start. Everything soldered and wrapped tight. Kreg, you and many other guys have been incredibly helpful and patient with many of us that don't do these installs regularly. It is very fun and rewarding when it's finally done and everything works like its suppossed too. THANK YOU GUYS VERY VERY MUCH I do have a couple fun features I'd like to look into now though. I'd like to pop the trunk at all time and use a few aux channels for the sun roof and different window up down stuff. This car has a feature that it will drop all 4 windows and open the sun roof with a right key turn in the driver door. I'd like that on an aux if possible. Thanks again guys

  Good job!       The first one with an iDatalink module can be trying, after that they are real easy. 

Soldering is fun!