no output on igntion 1 h3/1

Hello, I have a Python 5706P remote start installation that is kicking my butt. Installed with a DBALL in an 09 Corolla. Ignition 1 Pink wire H3/1 does not go to +12 during remote start.   Car will not start as a result. With Pink jumped to 12 volts during start system works fine. Red, red black and red white are all wired to +12 constant and verified at remote start module. Sent brain box in once thinking that there was a problem with internal relay. Replacement module does the the same thing.   Is there any programming features that would affect H3/1? Any jumpers or wires need to be changed to allow H3/1 to operate correctly? Or is this a bad module? My understanding is H3/1 should go to +12 volts when attempting remote start. Thanks

I just looked at at a 5706 Install Guide. It shows the pink IGN1 as H3/10.   Not H3/1. In the install guide diagram., H3/1 is empty. H3/2 is a RED / blk, so the RED / blk should be next to an empty cavity. H3/9 is a RED / wht, so the RED / wht should be next to a pink. Perhaps you got a mis-pinned harness connector?

My guide is showing H3/1 Pink   (+) Ignition 1 Input/output; H3/10 NC   no connection. Anyway all measurement have been on the pink wire exiting the 10 pin heavy Gage connector. On the outside chance that harness was wrong I did Probe the open pin that should be H3/10 and found that was 0 volts during remote start.

Ambiguity and confusion from DEI Installation materials??? Whoda' thunk? It was worth a try.

Think they now call it pin 6 but WTH, I never read their instructions, long history of typos.

Have not figured it out. Still not output on Pink ignition 1. Diode isolated Ignition 2 to ignition 1 and ignition 2 and system works fine. But is not working as it should. please reply if anyone has any ideas.

Relay out from H2 pink NEG ignition output, that's a work round. Do not diode out from ignition 2 to ignition 1, Toyota keeps those leads separate for good reason.

I agree relay would be a better work around than diode Isolation. Diodes were a quick fix to get it going for now.   I have installed 2 other DEI systems with the Responder LC3 brain box and have had no trouble with Ignition 1 output.   I cant believe I would get 2 bad modules. Seems like I must be missing something simple. Items that could affect ignition 1 output: 1. Safety interlock - I think these affect only start output. 2. Feature option - Does not make sense to affect Ignition 1 output. 3. Jumper or Fuse - Cant find anything that would affect Ignition 1. 4. Bad module - 2 for 2 - Really? Unless anyone can think of one of these reasons would cause this issue or any others I plan to add relay. Its Fairly nice in Minnesota this week. I am sure we will be in for some cold weather soon so I need to get this working right.

I just installed a viiper 4706v and it appears i had the same problem with the brain. There was no +12V coming from the pink wire during remote start. Dash lights would like up, but it would not crank. Did you get the same problem? I had to send my unit back and I am still waitng for them to test the thing for warranty issues.

Have you powered up H3 red, RED / white and RED / black to a constant 12V+ source?