popping sound through speakers

Home / the12volt's Install Bay / Car Audio / popping sound through speakers (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

808vip

Copper - Posts: 67

Joined: May 24, 2003

Location: United States

Posted: May 24, 2003 at 10:34 AM / IP Logged

When ever I roll up/down the passenger side window from either driver/passenger control there is a popping sound over my car's speakers. I own a 2002 Chevy Tahoe with an Eclipse AV8132 H/U, Eclipse PA5422 and a PA4212 amps, with Focal comps. in front and rear, and an Eclipse SW8122.4 sub. My installer thought it was the positive lead connection so he re-routed the conneciton. It still pops and now he thinks my truck has a faulty Body Control Module. Any other ideas or suggestions I should try?

Back to Top

mkyriss

Member - Posts: 9

Joined: May 29, 2003

Location: United States

Posted: May 29, 2003 at 11:10 PM / IP Logged

try changing your rca's and make sure your not useing factory speaker wires

they could be sorted out to a window switch wire

Back to Top

Okoboji

Member - Posts: 35

Joined: May 31, 2003

Location: United States

Posted: May 31, 2003 at 8:49 PM / IP Logged

This is a common problem that happens when car wiring degrades.... it gives off electrical impulses that your speaker wire picks up as a "poping" you need to replace the OEM speaker wire with a after market kind that will block that noise.... they are usually called "low noise speaker wire"

Back to Top

Sound Pressure

Silver - Posts: 711

Joined: March 09, 2002

Location: United States

Posted: May 31, 2003 at 11:01 PM / IP Logged

Check your ground wires if it is on an amp. Check to make sure that you have enough clearance from the speaker and the window to roll down with out banging into it.

Sound Pressure

You know you have the right amount of pressure when your eyes start to water! Now you've got Juice!

Back to Top

Search for other posts by Sound Pressure

808vip

Copper - Posts: 67

Joined: May 24, 2003

Location: United States

Posted: June 01, 2003 at 5:04 AM / IP Logged

the installer replaced all oem speaker wires..need to go back and check on clearance...

Back to Top

808vip

Copper - Posts: 67

Joined: May 24, 2003

Location: United States

Posted: July 18, 2003 at 2:57 AM / IP Logged

sorry guys for not posting this earlier...the installer traced the problem to bad RCA's (good call mkyriss)

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

popping sound through speakers

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.