2009 Smart ForTwo Remote Start

Anyone have a diagram for one of these, has factory anti theft installed also. thanks

DIRECTWIRE™ WIRING INFORMATION - SMART / FORTWO / 2009 / Remote Start 12volts red (50A) + dash fuse box, rear, black 3 pin plug, pin 3 Starter purple + dash fuse box, rear, white 2 pin plug, pin 1       Ignition RED / black + dash fuse box, rear, black 2 pin plug, pin 1 Second Ignition RED / blue + dash fuse box, rear, black 2 pin plug, pin 2 Power Lock pink (relay isolate from switch) - power lock switch or dash fuse box, rear, white 40 pin plug, pin 12 Power Unlock BLACK/ blue - power lock switch or dash fuse box, rear, white 40 pin plug, pin 16 Lock Motor gray / YELLOW 5 wire dash fuse box, rear, brown 8 pin plug, pin 4 Unlock Motor pink 5 wire dash fuse box, rear, brown 8 pin plug, pin 5 Parking Lights+ gray/blue + headlight switch or dash fuse box, rear, black 40 pin plug, pin 10 Hazards PURPLE / blue - hazards switch or dash fuse box, rear, black 40 pin plug, pin 31 Turn Signal(L) BLACK/ white + dash fuse box, rear, white 40 pin plug, pin 1 Turn Signal(R) BLACK/ green + dash fuse box, rear, white 40 pin plug, pin 11 Reverse Light yellow/red + left rear taillight, black 6 pin plug, pin 4 Door Trigger yellow/white - dash fuse box, rear, black 40 pin plug, pin 4 Dome Supervision BROWN / blue - dash fuse box, rear, white 40 pin plug, pin 4 Trunk/Hatch Pin blue/black - dash fuse box, rear, black 40 pin plug, pin 2      Trunk/Hatch Release pink / YELLOW (rear handle switch) - dash fuse box, rear, black 40 pin plug, pin 36       Factory Alarm Arm (arms on lock with door open)      Factory Alarm Disarm (see disarm no unlock)      Disarm No Unlock (transponder and ignition)      Tachometer yellow/blue, purple, or pink ac any fuel injector, gray 2 pin plug, pin 1 Brake Wire BLACK/ red + driver kick, harness to rear Parking Brake BROWN / black - parking brake switch, 2 pin plug, pin 1 Horn Trigger blue + dash fuse box, rear, brown 8 pin plug, pin 6 warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. If i Can't Install it    I Don't need it   Joe

Thank you, do you have a bypass you would recommend for the remote starting?

it looks like DEI or IDATALINK do not make a bypass module for this vechile. You could check FORTIN but i have not used a fortin bypass module myself so i could not give you any feed back on them.