Aps997e omega db all

Home / the12volt's Install Bay / Car Security and Convenience / Aps997e omega db all

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

bat9905

Copper - Posts: 131

Joined: January 13, 2008

Location: Washington, United States

Posted: December 05, 2015 at 4:14 PM / IP Logged

Just finished this 07 compass but the vehicle is not starting . Originally went wire to wire mode I programmed bypass . When I send command to start ignition comes on like it is attempting but fails to turn over . Anyone have any ideas

bat9905

Back to Top

bat9905

Copper - Posts: 131

Joined: January 13, 2008

Location: Washington, United States

Posted: December 05, 2015 at 4:47 PM / IP Logged

I should also mention I had it re flashed and went data mode with same results . For both modes I follow directions to the diagram .

bat9905

Back to Top

bat9905

Copper - Posts: 131

Joined: January 13, 2008

Location: Washington, United States

Posted: December 05, 2015 at 10:31 PM / IP Logged

Someone has to know something . I know we shouldn't assume with wiring but I pulled can h and can l , ignition and mux about 12 " from transponder connector . Could this be the issue ?

bat9905

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.