where can i get connectors
Topic Closed)
Members
Search
Register
Login
Posted: May 27, 2003 at 5:26 PM / IP Logged
Posted: May 27, 2003 at 6:14 PM / IP Logged
Posted: May 28, 2003 at 4:50 PM / IP Logged
Not to be a nervous nelly but watch out for T-taps. They are notoriously unreliable and often the "weak link" that bite you in the butt on an install or even customer comebacks.
Better option would be to cut the wire you want to tap into, twist one end of the cut wire with the "tap" wire and put them into a seamless crimp connector, double strip the other end of the cut wire, fold it over and put it in the other end of the connector and crimp. This gives a positive contact everytime.
R Jackson
Owner/Installer
TRM Emergency Vehicles
Information is advice only and should be confirmed with OEM or quality test equipment.
Boyertown, Pennsylvania
R Jackson
Owner/Installer
TRM Emergency Vehicles
Information is advice only and should be confirmed with OEM or quality test equipment.
Boyertown, PennsylvaniaSorry, you can NOT post a reply.
This topic is closed.
Printable version
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com 
Sunday, May 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Sunday, May 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
