Viper 4806v and ALCA

Home / the12volt's Install Bay / Car Security and Convenience / Viper 4806v and ALCA

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

mhunguyen

Member - Posts: 32

Joined: February 27, 2016

Location: Massachusetts, United States

Posted: October 11, 2016 at 8:26 PM / IP Logged

I am planning to put a 4806v on a 2014 Toyota Rav4 using Idatalink ALCA, just have a few questions hoping to get some help.

Based on the Idatalink guide for firmware ADS-AL(DL)-TL6-EN, it's saying WARNING: DO NOT CONNECT ANY OTHER ACCESSORY,IGNITION OR START WIRE FROM THE REMOTE STARTER TO THE VEHICLE. THE INTERFACE MODULE IS HANDLING THE REQUIRED VEHICLE POWER AND START SEQUENCE FROM THE PUSH TO START BUTTON CIRCUIT. This is pretty straight forward, but is it saying not to connect the following 12volt wires as well on the 8-Pin Harness?

RED / BLACK (+) 12VDC CONSTANT INPUT for ACC and starter relays

RED (+) 12VDC CONSTANT INPUT for ignition 1 relay

Also on the 6 Pin connector is this the parking light output wire?

WHITE - PIN 30 of LIGHT FLASH RELAY

thanks

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 12, 2016 at 2:49 AM / IP Logged

The 4806 has separate main power and ground so they are not needed to power the onboard remote start relays.

Yes it is the light output for the parking lights.

Back to Top

mhunguyen

Member - Posts: 32

Joined: February 27, 2016

Location: Massachusetts, United States

Posted: October 13, 2016 at 2:45 PM / IP Logged

lurch228 wrote:

The 4806 has separate main power and ground so they are not needed to power the onboard remote start relays.

Yes it is the light output for the parking lights.

THank you Lurch... is this the same case if i were to use the 5806 instead of the 4806?

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 13, 2016 at 3:45 PM / IP Logged

Yes same with any R/S capable unit or brand.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.