12 VOLT CONSTANT (1)PINK (+) and (1)ORANGE (+) @ IGNITION SWITCH HARNESS
STARTER GREEN (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 GREEN (+) @ IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY /HEATER BLOWER 1 BLACK (+) @ IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2 RED (+) @ IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) YELLOW/BLACK (-) @ HEADLIGHT Switch or BCM, 20-Pin Plug, Pin 4, See NOTE *1
PARKING LIGHTS ( + ) GRAY (+) Left and GRAY (+) Right, use both! See NOTE *2 @ FUSEBOX, REAR BROWN 12-Pin Plug, Pins 2 and 8
POWER LOCK PINK/BLACK (TYPE B) @ DRIVERS KICK PANEL or BCM, 20-Pin Plug, Pin 3, See NOTE *1
POWER UNLOCK BROWN (TYPE B) @ DRIVERS KICK PANEL or BCM, 20-Pin Plug, Pin 11, See NOTE *1
LOCK MOTOR WIRE PINK/BLACK (5-WIRE TYPE) in DRIVERS KICK PANEL @ DOOR HARNESS
DOOR TRIGGER YELLOW/ORANGE (-) @ BCM, 24-Pin Plug, Pin 22, See NOTE *1
DOMELIGHT SUPERVISION BLUE (-) in DRIVERS KICK PANEL or @ BCM, 16-Pin Plug, Pin 1, See NOTE *1
TRUNK RELEASE WHITE/ BLACK (-) Requires Relay Part #775 in DRIVERS KICK PANEL or @ BCM, 20-Pin Plug, Pin 13, See NOTE *1
SLIDING POWER DOOR N/A
HORN WHITE (-) Requires Relay Part #775 @ HORN Switch or in DRIVERS KICK PANEL
TACH YELLOW/BLACK (AC) in DRIVERS KICK PANEL, GRAY 33-Pin Plug, Pin 5
WAIT TO START LIGHT N/A
BRAKE Wire turns from BROWN to RED (+) @ SWITCH above BRAKE PEDAL or in DRIVERS KICK PANEL
FACTORY ALARM DISARM ORANGE (-) See NOTE *3 in DRIVERS KICK PANEL or BCM, 20-Pin Plug, Pin 2, See NOTE *1
ANTI-THEFT KIA's TRANSPONDER ANTI-THEFT System, See NOTE #4 @ IGNITION SWITCH TUMBLER
NOTES
NOTE *1 The BCM (Body Control Module) is located to the LEFT of the STEERING COLUMN.
NOTE *2 The (+) Positive Parking Light circuit on this vehicle requires connecting to (2) wires, this connection will require (2) Extra relays to connect
NOTE *3 Testing of this wire must be done while Turning the Key in the Drivers Door Key Cylinder.
NOTE #4: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM,
~wirewise~
Verify all wiring with your meter before making any connections!