1.) Remote Starter: Re-confirm that the remote start still starts the vehicle with the key in the ignition and the EVO-ALL unplugged (since you've re-learned tach, changed viper settings, etc.).
-Vehicle starts with no issues using the key and the EVO-ALL unplugged.
2.) Bypass: Remove the key, plug the EVO-ALL back in and take the EVO-ALL Dark Blue wire and place it to ground. The EVO-ALL Red LED should be on. At this point, you are simulating the key in the ignition with the bypass. Now try and remote start the vehicle. If the vehicle remote starts This will tell you that the EVO-ALL is OK/programmed correctly, and there is most likely an issue with the Status output from or the connection to the Viper. If it doesn't start, carefully verify your EVO-ALL connections including the EVO-ALL power and ground. If the vehicle still is unable to start after all of the connections are verified (and there are only a few in this application), reprogram the bypass and repeat the remote start attempt with the bypass isolated.
-Still does not start with dark blue wire grounded, confirmed with red led on EVO-ALL. All connections re-checked and verified on the EVO-ALL. Re-programming the bypass did nothing.
3.) Once the bypass is operational, remove the ground from the EVO-ALL Dark Blue wire and reconnect the GWR connection from the Viper.
-Still not operational.
Update:
I have confirmed my connection to tach wire has a good signal. I switched to virtual tach and it did the something but this time errors with 'Low Voltage'.
I checked my voltage level and noticed that my battery is not charging when remote started.
Example:
-Resting voltage is 12.5v, start vehicle with key, idle voltage is 14.5v.
-Resting voltage still at 12.5v, remote start vehicle, vehicle turns over for 2-3 seconds and voltage still remains around 12.5v before it automatically shuts down.
Could it be that it is not sensing the vehicle is on via voltage thus not remaining on? What could cause the alternator not to kick on when remote started?-Vehicle starts with no issues using the key and the EVO-ALL unplugged. -Vehicle starts with no issues using the key and the EVO-ALL unplugged.
Here is a video clip:
https://www.youtube.com/watch?v=eSpJNsKS-qs