2011 Kia Sorrento Remote Start Wiring

Does anyone have any links or info on what wires I need to splice to install a remote starter. The car model is below. Vehicle: Kia Sorento 2011. Platinum. EX Key-less Entree Factory Installed. 3rd party unit to be installed. Remote Starter. Avital Model 4105L (Could be a viper model 4105v) Sites such as installation guides already downloaded pdf. avital com/Support/OwnersGuide.aspx Avital - Guides and Manuals S P A M com 2011-kia-sorento-remote-start-system-wire-diagram/]2011 Kia Sorento Remote Start System Wire Diagram and readyremote com I would appreciate it so much if someone has done this before on this car. I will not cut the yellow wire, and will not use a globe meter reader. Thankyou

SORENTO      2011-2013 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      RED (+), NOTE #2      @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 1       STARTER      GREEN (+), NOTE #3      @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 3       STARTER 2      BLACK/ORANGE(+) and PINK(+), (PUSH to START Button)      @ STAR/STOP BUTTON SWITCH, (BLACK, 10-PIN PLUG), PINS 1 and 7       IGNITION 1      ORANGE (+), NOTE #4      @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 4       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY/HEATER BLOWER 1      BLUE (+), NOTE #5      @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 2       ACCESSORY/HEATER BLOWER 2      YELLOW (+), NOTE #6      @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 6       KEYSENSE      N/A            PARKING LIGHTS ( - )      BLUE (-)      @ HEADLIGHT SWITCH, (WHITE, 13-PIN PLUG), PIN 2       PARKING LIGHTS ( + )      GREEN(+)(Left) and YELLOW(+)(Right), use both!      @ DASH FUSE BOX, (WHITE, 39-PIN PLUG(A), PINS 11 and 7       POWER LOCK      BLUE/BLACK (TYPE B)      @ DASH FUSE BOX, (WHITE, 26-PIN PLUG(FK), PIN 4       POWER UNLOCK      GRAY/BLACK (TYPE B), NOTE #7      @ DASH FUSE BOX, (WHITE, 26-PIN PLUG(FK), PIN 24       LOCK MOTOR WIRE      ORANGE (5-Wire Type)      @ DASH FUSE BOX, (WHITE, 39-PIN PLUG(A), PIN 16       DOOR TRIGGER      GREEN/ORANGE (-)      @ DASH FUSE BOX, (WHITE, 26-PIN PLUG(FK), PIN 10       DOMELIGHT SUPERVISION      BROWN (-)      @ LEFT FRONT A Pillar, (WHITE, 22-PIN PLUG), PIN 1       TRUNK RELEASE      YELLOW/BLACK (-), NOTE #9      @ DASH FUSE BOX, (WHITE, 26-PIN PLUG(FK), PIN 11       SLIDING POWER DOOR      N/A            HORN      GRAY/BLACK to GRAY (-)      in DRIVERS KICK PANEL, (WHITE, 15-PIN PLUG), PIN 6       TACH      Any wire NOT ORANGE or PINK/BLACK, (AC)      @ Any FUEL-INJECTOR       WAIT TO START LIGHT      N/A            BRAKE      NOTE #10      @ BRAKE PEDAL SWITCH, (WHITE, 4-PIN PLUG), PIN 1       FACTORY ALARM DISARM      PINK(-) and GRAY(-), use both, NOTE #8      @ DASH FUSE BOX, (WHITE, 26-PIN PLUG(FK), PINS 9 and 26       ANTI-THEFT      KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1      @ IGNITION SWITCH TUMBLER       NOTES NOTE #1: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM, check the OWNERS MANUAL for this vehicle or contact your HYUNDAI Dealer to see if the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE STARTING you will need the 791 BYPASS Module and an Extra Ignition key. NOTE #2: on Vehicles with SMART KEY, this wire is located in the DRIVERS KICK PANEL, (WHITE, 15-PIN PLUG), PIN 12 NOTE #3: on Vehicles with SMART KEY, this wire is a RED (+), located at the DASH FUSE BOX, (WHITE, 8-PIN PLUG(C), PIN 4 NOTE #4: on Vehicles with SMART KEY, this wire is a GREEN (+), located at the DASH FUSE BOX, (WHITE, 8-PIN PLUG(C), PIN 3 NOTE #5: on Vehicles with SMART KEY, this wire is located at the DASH FUSE BOX, (WHITE, 8-PIN PLUG(C), PIN 2 NOTE #6: on Vehicles with SMART KEY, this wire is located at the DASH FUSE BOX, (WHITE, 8-PIN PLUG), PIN 1 NOTE #7: to UNLOCK just the DRIVERS DOOR, use the YELLOW/BLACK (-), at the DASH FUSE BOX, (REAR WHITE, (16-PIN PLUG(MM), PIN 2 NOTE #8: to DISARM, use the PINK (-), TYPE B, and the GRAY (-) use both wires, will Require a Double Pulse. TEST these wires while turning the KEY in the Drivers Door. NOTE #9: TEST this wire while Opening the TAILGATE with the Handle on the REAR of the Vehicle. NOTE #10: the BRAKE wire is a YELLOW(+)(2.4L Engine) and a GREEN/BLACK(+)(3.5L Engine)~wirewise~ Verify all wiring with your meter before making any connections!

Thank you so much guys. I have seen this thread a couple of days before I joined this website. I will find out if I realy need a 791 BYPASS Module. This car has a centre column to put in your key remote if the battery is flat. So possibly this could be the bypass module. I will find out. The details on this site you have given is great but, would there be a little more detail in the notes? some images of past successful installs? Cos I can see the colors don't match with a few of the white 26 pin plug connections. I will show some images of the fuse box when I get a chance to upload them.