Viper 211HV Dome Light Connection

Regarding dome lights. The manual has the following: .................. H1/4 Black/White (from Primary Harness Wire Connection Guide) "Connect this wire directly to the domelight circuit in the vehicle. The on-board relay will drive circuits up to 30 amps. The polarity of this output is determined by the connection of the input wire H1/3 in the Relay Harness" .................. So no external relay needed but then in the features section it has: .................. IGNITION CONTROLLED DOMELIGHT "If turned on [the feature], the system will turn on the domelight for 30 seconds when the ignition is turned off. The domelight supervision output H1/4 wire must be connected to an optional relay as described in the Primary Harness Wire Connection Guide." .................. Why does it need an optional relay if it has the on-board one? In searching this forum I found mention that if it has two wires for the dome light then it has the onboard relay and the 211HV does (1/3 and 1/4) but don't want to risk frying anything should would appreciate some clarification on why the 'feature' says to use a relay.

The H1/3 and H1/4 wires are the same as contacts 30 and 87 on a relay. I'm guessing a previous 211 model didn't have a relay. DEI used an old manual didn't proofread. On page 4 of the manual that I have shows primary harness H1 having 12 positions. The description below shows 18 positions.

Perfect. Thank you. My favorite part of the manual is the factory disarm wire: .............. H1/13 LT. GREEN/BLACK Factory Alarm Disarm This wire supplies a .............. The suspense is killing me

You'll have to read Directed's next manual (or at least the manual that section was copy and pasted from) to find out.