the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Low Voltage Relay Noise


Post ReplyPost New Topic
< Prev Topic Next Topic >
grey ghost 
Member - Posts: 1
Member spacespace
Joined: April 11, 2022
Location: Florida, United States
Posted: April 11, 2022 at 8:03 PM / IP Logged Link to Post Post Reply Quote grey ghost
I have a 2004 BMW Z4 2.5i, on which I installed some aftermarket DRLs. It is simple enough to wire them with an accessory wire signaling a relay, but I am not simple. I decided I wanted them to turn on when I unlock the car, but my car doesn’t have a factory alarm system, so the other lights don’t flash. This was also not too complex as I found a wire inside the Central Locking System module that gives a signal for about 20 seconds after unlocking the vehicle. So I wired two relays to the lights, one triggered by an accessory power and one triggered by the locking system wire. So far this is all within my capabilities.
The issue that has arisen is that the locking system wire doesn’t shoot straight to 12v when the car is unlocked, it takes 1-2 seconds to build up to 12v. My multimeter shows it increases incrementally for that 1-2 seconds. This caused the relay to make a very distinct buzzing sound while the power builds, and it is quite unnerving.
I have 2 possible ideas to resolve this issue, but both are not things I have much experience with. I believe I could run a diode straight from the Central Locking System to the lights, which would prevent backfeeding the locking system with the other relay (from the accessory power). The other idea is some kind of way to filter out the lower voltages from getting to the relay, not sure if a capacitor could achieve this or some other way of only letting 12v+ to reach the relay.
Any ideas are greatly appreciated and any information on diodes or capacitors, if I’m mistaken on what they’re capable of let me know.
I can try to draw some diagrams up later and post them maybe tomorrow.
hav007-roco 
Member - Posts: 9
Member spacespace
Joined: April 13, 2022
Location: Ontario, Canada
Posted: April 13, 2022 at 3:08 AM / IP Logged Link to Post Post Reply Quote hav007-roco
Take Lock unlock directly from switch in center. Depending on the unit I belive you double up arm/disarm and connect to 1 wire from switch connect.
Rocky Verma

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, February 2, 2023 • Copyright © 1999-2023 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer