2003 Mazda 6, Keyless Entry

good day any help please,im trying to install keyless entry 2003 mazda 6.but the driver door wont lock\unlock but the other doors will.how do i fix itjigga the boss

Which wire of the vehicle did you tap into? Did you use relays and a resistor? Power Lock      Lt. Green      - 1000 Ohms      Driver Kick --or-- Door Lock Module high above passenger kick            Power Unlock      (same as power lock)      -                 Lock Motor      Red/Blue      Reverse      Driver Kick --or-- Door Lock Module high above passenger kick            Driver Unlock Motor      Red/Green      Reverse      Driver Kick --or-- Door Lock Module high above passenger kick            Passenger Unlock Motor      Red/Black      Reverse      Driver Kick --or-- Door Lock Module high above passenger kickLet's Go Brandon Brown. Congratulations on your first Xfinity Series Win. LGBFJB

The car has the chip key ,but I just apply power and grounds wire.the remote system says I should find the driver door manual lock unlock and also the driver door switch and connect to the remote system but I can't locate those wires,so as it stands now the driver door lock mechanism will move accordingly but it doesn't lock,it only lock with the key manually jigga the boss

sounds like the drivers motor is dead..

But the key will lock and unlock the car ,if the motor is dead ,tht would not bejigga the boss

lock needs negative pulse through a 1400 ohm resistor. door lock wiring diagramsSteve G

Thanks,I'm an average DIY guy so for this to work I'll need to install this resistor in the wiring harness.jigga the boss