Viper 4105 Not Holding Program Changes

Hi guys did everything the manual said to programing and the alarm always respond correctly with the chirpings and the led blinking confirming my changes, what the manual don't specifically said is how to finish the programming or end it and store the changes. When I trayed the new parameters then nothing happened, like if did nothing. thanks for the help.

Are you programming this on a bench or installed in a vehicle? What wires are you using? Did you verify them with a meter? What steps are you taking to exit programming?

Hi, thanks for your answer, Im doing it in a bench since it is freezing outside, I'm using the pink wire for activate the programing (ignition on/off) Everything works fine but I'm not sure how to get out of programing, a video I saw he just turn the ignition on again. The manual doesn't specifically said how get out of programming. Im trying to activate the starter with 2 button pulses and keep the car running for 24 minutes not the 12 minutes default. Menu 2 feature 2 option 2 for the minutes of running Menu 2 feature 5 option 2 for the two pulses starter. Thanks!!

If you search the downloads section for 4105 you will get manuals. "The Learn Routine exits if any of the following occurs: • The ignition is turned ON. • There is no activity for 30 seconds. • The Control Center button is pressed too many times."