Jeep Grand Drivers door sense volt high?!

Home / the12volt's Install Bay / Car Security and Convenience / Jeep Grand Drivers door sense volt high?! (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

brivalen

Member - Posts: 31

Joined: March 23, 2003

Location: United States

Posted: June 19, 2003 at 4:08 PM / IP Logged

I am trying to install an DEI 554T alarm on my 2001 Jeep grand cherokee. I found the TAN/RED wire at the drivers door switch but when the door is open i am getting a solid 7 volts and when the door is shut i get 12. What is up? Will the 554T recognize a (-) trigger when its reading 7? I have my digital volt (+) hooked right to the battery and (-) going to the TAN/RED to test.

What is going on here?

Brian

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: June 19, 2003 at 4:54 PM / IP Logged

Here is what I have for the Jeep:

There are 4 separate door triggers wire, one for each door. Use all 4 wires and diode isolate each together. The drivers door is tan/red at the drivers door lock switch. The passenger door is tan/red at the passengers door lock switch. The drivers rear door is tan/orange and the passengers rear door is tan / YELLOW at the BCM.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

djfearny2

Silver - Posts: 810

Joined: September 23, 2002

Location: United States

Posted: June 19, 2003 at 4:58 PM / IP Logged

my chart says it is yellow in a two pin connector in the drivers kick and it is. and you must use relays to activate and isolate the door locks.

Jon

Installer/Help Technician

---coral springs florida---

mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: June 19, 2003 at 9:07 PM / IP Logged

Use a DEI 455J for the doorlocks and door trigger. It will allow you to use the underdash light for the door trigger. It gets around the problem of the domelight turning on for 2 seconds when you remote start by providing an output to temporarily interupt the door trigger with a relay.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Jeep Grand Drivers door sense volt high?!

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.