Subaru Impreza WRX (J) install directions

Just trying to install the 12 volt keyless entry model but I have a bad feeling that hte driivers door has no actuator istelf..  Just watned any help as to any suggestions around this problem as well as detailed wiring directions on what type ( 3door pos) I will be working with..l

Thanks

You are trying to install a keyless entry unit into this vehicle ?? If so you will need to run two wires per door for the actuators and then run two relays to them. Here's a diagram for the door lock actuators : http://www.hometronicz.com/ebay/dlm/aftermarketdl.swf

If this is not what you want please post in more detail what you are looking for.

The Subaru WRX generally has no door motor in the drivers door. You will need to fit one. Space is limited (it gets real close to the window) so it is best to use the smaller gun type actuators.

Just wire your remote module to the added door motor ( inthe drivers door) and all will work fine

Cheers,

Glynn

Thanks to you both!!  I was doing the intell as well and yup... no actuator in the drivers door.. Researching the location of one now from a WRX here in Japan.. After which I will work the install and wiring and then integrate in the keyless lock system.. thanks again for helping verify my troubles and giving me some added support.. 

J

Anytime J, post your questions and we're here to help.