trailblazer remote start

i Have installed a autopage 610 with the gmld and pldata units....the keyless system works fine with the new remotes and the windows roll up....but I still can't get the remote starter to work..the pldata is programmed correctlyand is on operating postion....anyone else run into this problem and if so how do i solve itchad_m_m

you likely need to enter programming mode before the starter will even attempt to start. That is how the two Autopage models I sell work. Look in your manual toward the back where it outlines the start feature programming. It will refer to testing the start features and this is what you need to do. Read the entire section. J Rilla

Owner/Installer

What happens when you attempt to start the car remotely? Does the Ignition turn on and then no cranking? or does nothing happen at all? Watch your security light on the dash when you start the truck with the key and compare it to how it acts when you try to remote start it. There could be aby number of problems, but I will need as much detail as you can provide. J Rilla

Owner/Installer

im the programing mode rpm test and sets...then it says to remote start to finish for the crank time programing and I get nothing no crank no attempt from the alarm to start i have grounded the toggle switch and the hood pin switch everthing else is hooked up properly the pldata programmed and is in operating positon the glmda is working properly also what other info do u need? chad_m_m

the thing that has caught me several times with the autopage units when they won't attempt to crank it the neutral satey switch, make sure that it is grounded.Just a Guy, Wiring up those Vehicals

---------------------------------

Gool_Greg

Well, if the hoodpin wire is grounded, the unit thinks the hood is open... that can't be right.