Can I hook up 2 comp vr's to a mono amp?

I was wondering if i get 2 12 kicker comp vr's, and i get a kicker class D mono DX700.  Would this amp be enough for these subs?

For 2 CompVR's I'd suggest either... 1) (2) 4ohm 12" CompVR's and (2) KX400.1 Class D mono amps. The subs are 400RMS 800Peak, and the amps are 400 x 1 @ 2ohms. Each sub would be wired in parallel to its own amp, running a 2ohm load per amp. Each sub would receive 400 watts. 2) (2) 4ohm 12" CompVR's and (1) KX800.2 Class AB 2-channel amp. The subs are 400RMS 800Peak, and the amp is 400 x 2 @ 2ohms. Each sub would be wired in parallel to its own channel, running a 2ohm load per channel. Each sub would receive 400 watts. Squirrel

"No more Cpt. Kirk chit chat"

If its too loud, then you're too old

Donate to the12volt.com

just to make sure, the comp vr's you describe are dual VC right at 4 ohms each?

Correct. (1) 4ohm DVC can be wired in parallel for a 2ohm total load. So it would be 1 sub per KX400.1, or 1 sub per channel on a KX800.2Squirrel

"No more Cpt. Kirk chit chat"

If its too loud, then you're too old

Donate to the12volt.com

get a audiobahn 1200.1 class d amp.