alarm installation help please!

Home / the12volt's Install Bay / Car Security and Convenience / alarm installation help please! (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

chad11

Member - Posts: 11

Joined: August 25, 2003

Location: Canada

Posted: September 10, 2003 at 8:09 PM / IP Logged

driving a 96 z24 and i've got most of the install done. but now its down to the door locks and trunk release. i went to my local electronics store and got 2 relays for my doors. i dont think these are the right relays? they are

Bestar (BS-902cs)

NO 20A 240VAC/28VDC

NC 15A 240VAC/28VDC

COIL 12VDC

will these work in my car? i wired them as to the 12volts specs for a " 5 Wire Alternating 12 Volts Positive Door Locks" is this correct?

also i can't find the damn tach wire? white at coil? whats the coil? =) one more thing? does my car have passlock 1? how to bypass?

any help would be awesome! thanks in advance

chad11

Member - Posts: 11

Joined: August 25, 2003

Location: Canada

Posted: September 10, 2003 at 8:33 PM / IP Logged

one more thing... i have a 2way panther /emote start alarm sytem

CBates

Copper - Posts: 58

Joined: September 08, 2003

Location: United States

Posted: September 10, 2003 at 9:45 PM / IP Logged

I personally wouldnt use them. I would only use Bosch type relays. I only use Bosch, or Potter Brumfeld. They look like this:

alarm installation help please! -- posted image.

You can order them anywhere on the net, including ebay, and Parts Express. Make sure you get SPDT(Single Pole Double Throw).

Hope this helps

Chris

profuse007

Gold - Posts: 2,015

Joined: October 20, 2002

Location: Texas, United States

Posted: September 10, 2003 at 11:20 PM / IP Logged

yeah, part express is the least exp relays i have found. good place to shop

Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

StealthEs

Copper - Posts: 326

Joined: September 04, 2003

Location: New Jersey, United States

Posted: September 11, 2003 at 9:19 AM / IP Logged

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / CAVALIER / 1996 / Security

[PRINT THIS PAGE]

12volts	red	+	ignition harness
Starter	yellow	+	ignition harness
Ignition	pink	+	ignition harness
Power Lock	lt. blue		either kick panel
Notes: Non keyless cars, locks are 5wi (type C) and they are mastered from the passenger side switch. Keyless cars, locks are positive trigger (type A).
Power Unlock	white		either kick panel
Notes: Non keyless cars, locks are 5wi (type C) and they are mastered from the passenger side switch. Keyless cars, locks are positive trigger (type A).
Lock Motor	gray		drivers kick panel
Unlock Motor	tan		drivers kick panel
Disarm Defeat	tan		passengers kick panel
Parking Lights+	brown		harness to rear, dkp
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger	grn/blk & lt. blue	-
Notes: The GREEN/ black is located in the lower drivers kick panel. It catches the drivers door only. The light blue is located in the lower passenger kick panel, and catches the passenger door(s). Tap both wires and diode isolate each.
Dome Supervision
Trunk/Hatch Pin	black	-	trunk light
Hood Pin
Trunk/Hatch Release	BLACK/ white	+	keyless module
Notes: The keyless module is located in the left side of the trunk behind the rear seat.
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer		ac	engine harness
Notes: The engine harness is found next to the battery, below the radiator hose, just above the transaxle. Use white or orange on the 2.2L motor, and PURPLE / white on the 2.4L motor.
Horn Trigger	black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: Yes	Type: Passlock 1	Part #: 555L or 555T
Notes: N/A

Cris

floaterr

Silver - Posts: 383

Joined: December 07, 2002

Location: United States

Posted: September 11, 2003 at 9:48 AM / IP Logged

Heck, even walmart carries the relays now. At least the Walmart I go to.

chad11

Member - Posts: 11

Joined: August 25, 2003

Location: Canada

Posted: September 14, 2003 at 9:31 AM / IP Logged

guys thanks a lot for the help! everything worked out awesome.. you guys rule =)

chad

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

alarm installation help please!

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.