troubles shooting ?

Hi

i was installing a crime stopper alarm on my car

(97 honda prelude)

and i forgot to disconected the battery while working

now the alarm and the remote start seem to working fine

and i did took out junky wires for the moble and booster hand phone

the car will start(crank) but the engine would not running

even if i manual start the car ( use the key)

do you're think i blew up some fuse ?

i did check all the fuses

there is one fuse broke

it's horn reply fuse , and i replace it , but the problem won't go away

sound like nothing wrong but it just won't running

so far .. i had try these ... and won't work

reset ecu

charge battery

take out all the fuse and put it back

shark plug does fire

do you think the moble hand phone have to do with it ?

i double check it ... but there is thing unusual

i need all the help and i dea i could get

thanks alots

this is my second time installation an alarm

so there is more problem then i could think of

from my point of view .. i can't fig-out the problem

so any advise/idea would help alot

please don't leave out any detail

Did you by chance install an ignition disable relay and had the wires hooked up wrong in the N/C position when it was supposed to be N/O ??

i didn't install any ignition disable/starter killer

the ignition and the acc light up and seem to work fine

yeah i still have the dash off, i want to test and make sure everything is working b 4

i start to put everything back

that maybe the only reson why it won't start

i am going to try to put the dash back on now

back later  .. with more info hehehe

it work now

after a messing with it a while

but the remote start is not working

it only start when i pull out the ignition 2/acc

but the car won't run with that

when put it back

the alarm just turn on the ignition then off right after that

??????????????????