how should i wire these subs

Home / the12volt's Install Bay / Car Audio / how should i wire these subs (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

weed101160

Member - Posts: 1

Joined: July 21, 2002

Posted: July 21, 2002 at 7:07 PM / IP Logged

i have a crunch mxb2250 amp and 2 kickercompVr10 subs. if someone could tell me how to wire these, that would be great

GlassWolf

Copper - Posts: 365

Joined: June 22, 2002

Location: South Carolina, United States

Posted: July 22, 2002 at 4:38 AM / IP Logged

if the amp is 2 channels, run one sub on each channel.

if this is a mono amp, wire the subs in parallel to the amp to get a 2-ohm load if they are 4-ohm drivers.

-GlassWolf

Pioneer Stage-4, Orion, DynAudio, Fi

Samantha

Member - Posts: 32

Joined: July 09, 2002

Location: Australia

Posted: July 22, 2002 at 5:25 AM / IP Logged

Just wondering would it be better to series the subs then bridge them onto the amp.

Sam

GlassWolf

Copper - Posts: 365

Joined: June 22, 2002

Location: South Carolina, United States

Posted: July 22, 2002 at 11:01 AM / IP Logged

if it's a mono amp (1 channel) and the subs are SVC 4-ohm drivers, wiring them in parallel will result in a 2-ohm load which will give the gentleman maximum rated power output for the amplifier. This would be the ideal way to do this.

I don't know if his drivers are SVC or DVC however, what the impedence is (per voice coil), or how many channels his amplifier is, so I was giving best case scenarios.

-GlassWolf

Pioneer Stage-4, Orion, DynAudio, Fi

Playtime

Member - Posts: 3

Joined: July 23, 2002

Location: United States

Posted: July 23, 2002 at 8:05 PM / IP Logged

too many variables to suggest anything. are the subs in a common or seperate chamber enclosure? impedance of subs? mono/stereo/multichannel amp? a lil more info would help.

If the box is chambered... you can run stereo or mono. If its common....id suggest mono (bridged). if the subs are 8 ohm.. just parallel and bridge....if the subs are 4 ohm.... series then bridge....the same if 2 ohm subs. If the subs are dvc...series the coils then parallel the subs bridged.

good luck

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

how should i wire these subs

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.