1998 Durango Door Locks

I've got a 1998 Durango that I have installed a Crimestopper RS900VI. Everything works, except the door locks. I hooked up a set of relays, as shown here: What am I doing wrong here?

The 1998 Durango use a type B (+) trigger system:

POWER LOCK                 ORANGE / purple       |+  |      blue plug in drivers kick panel       

POWER UNLOCK                pink/purple       |+  |     blue plug in drivers kick panel  

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Those are the two wires that I am using, but according to my Omega Software, it has a Reversal Rest at Ground System. That is not the case? So, I would need to use this:

Did you test those wires to see if they are (+) trigger ?Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

When the wires were cut I tested for the + so that I knew which was the switch side. I do get a + coming from the switch, but that is what I am supposed to get for the 5 wire, right?

abright I asked if it had factory keyless for a reason. The diagram says its a positive system as Jeff stated with factory keyless.  Without factory keyless it is a reverse polarity.   I suspect it has factory keyless since the reversal isnt working for you.

Sorry, I completely missed that question. Yes, it did have keyless entry from the factory.

Ok thats why they arent working. Wire them up like Jeff showed you above and you should be good to go.

I had tried it like that at one time, but couldn't get it to work, I will try it again, I may not have connected something properly. What if that doesn't work? I have moved on to another project and probably won't get back to that one for a few days. Just want to get the "What ifs" out of the way. Thanks guys. I never would have thought that the factory keyless entry would have an effect on it.