95 park avenue vats wire location

Home / the12volt's Install Bay / Car Security and Convenience / 95 park avenue vats wire location (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

tianlihu

Member - Posts: 34

Joined: October 08, 2003

Posted: February 06, 2004 at 1:50 AM / IP Logged

Thanks. but I don't know where is the boot, do you have any picture to illustrate the boot's location?

clearman

Member - Posts: 46

Joined: December 27, 2003

Posted: February 06, 2004 at 3:25 AM / IP Logged

It is in the door jamb. The rubber thing the wires go through to go into the door where the door hinges are.

tianlihu

Member - Posts: 34

Joined: October 08, 2003

Posted: February 07, 2004 at 2:44 PM / IP Logged

I just checked the driver boot for the factory disarm wire. A bundle of wires underneath the boot, but I was unable to find the Lt. green disarm wire. there is two larger size of Lt. green wire there. I checked them showing negative all the time ( with or without the key inserted to the door unlock postion). I noticed the these wires come from the driver's door.( the rubber tube exit has two bundle of wires, one goes down to the boot, the other goes up to upper dash panel.

Is the disarm wire always being checked out within the wires from the driver's door?

Can anybody tell me how to located the disarm wire?

Thanks

chriswallace187

Gold - Posts: 1,661

Joined: March 11, 2002

Location: Pennsylvania, United States

Posted: February 09, 2004 at 9:38 PM / IP Logged

Generally, on a car with a factory alarm with a disarm wire, the wire is run to the driver's key cylinder, so that if the owner unlocks the driver's door using the key it disarms the alarm also.

On some later model cars the wire only goes to the driver's door module inside the door(and you have to take the door panel off to get to it). Older model Park Avenues like that just ran the wire inside the car to the alarm module, however, so on that car you can get the wire at the door boot.

If you check all the wires and are 100% sure that there is no lt. green wire in the door boot harness, try not hooking up the disarm wire at all and see if anything happens when the remote start is activated or the doors are unlocked.

Search for other posts by chriswallace187

tianlihu

Member - Posts: 34

Joined: October 08, 2003

Posted: February 09, 2004 at 9:51 PM / IP Logged

Thank you, I already found the Lt. green wire at the rubber conduit exit run from the driver's door. and I connect it to the remote starter disarm wire. everything works fine now.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

95 park avenue vats wire location

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.