Creating a ground when armed wire?

Home / the12volt's Install Bay / Car Security and Convenience / Creating a ground when armed wire? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Ashez

Member - Posts: 26

Joined: May 08, 2004

Location: United States

Posted: May 16, 2004 at 12:44 PM / IP Logged

Is it possible to make your own ground when armed output? Reason is because I own a 2001 Mit. Eclipse with stock alarm with the Crimestopper RS900-IV. For those that arent familiar thats just the remote start and keyless entry, no alarm. Now... I won this 516T (voice module) off ebay, but I cant get it to work correctly. I dont have the diagram nor can I find it. But I think I remember that I needed a ground when armed output wire in order for it to work....

So is it possible to make your own ground when armed wire?

CutDog504

Silver - Posts: 637

Joined: May 14, 2002

Location: Louisiana, United States

Posted: May 17, 2004 at 10:54 AM / IP Logged

A 516t ?? Sorry to burst your bubble, but you cant do anything with that. That voice module can only be used with the Viper 800 series alarms. It comes with a small 3 pin data cable that plugs up to the viper brain. The brain sends all the messages to the voice module thru this cable. The voice module you need to properly work with ANY alarm is either a 516U or a 516L. The 516U can hook up to any alarm via the ground when armed wire. So can the 516l, except the 516l has a built in megaphone and you record your own messages (vulgar if you want).

Ashez

Member - Posts: 26

Joined: May 08, 2004

Location: United States

Posted: May 17, 2004 at 3:38 PM / IP Logged

The only harness is the main harness and I dont see a 3pin data cable output comming from it

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: May 17, 2004 at 10:38 PM / IP Logged

Try the yellow/black -third ignition or anti grind/starter disable wire. Program it as a starter disable and it should work.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

CutDog504

Silver - Posts: 637

Joined: May 14, 2002

Location: Louisiana, United States

Posted: May 18, 2004 at 12:34 AM / IP Logged

I'm sorry, the one I'm talking about with the data cable is the 516M. Never heard of a 516t. Was it used? Does it look like it might be an older model?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Creating a ground when armed wire?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.