wire diagrams for 04 park ave and avalanc

Home / the12volt's Install Bay / Car Security and Convenience / wire diagrams for 04 park ave and avalanc (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

ranquist

Member - Posts: 36

Joined: April 26, 2004

Location: United States

Posted: June 01, 2004 at 3:52 PM / IP Logged

Hi all, looking for up-to-date wiring for 04 park ave and avalanch. Thanx

Back to Top

jfk51502003

Copper - Posts: 221

Joined: March 04, 2004

Location: United States

Posted: June 05, 2004 at 3:28 PM / IP Logged

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / AVALANCHE / 2004 / Remote Start

[PRINT THIS PAGE]

12volts	red & RED / white	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	pink	+	ignition harness
Second Ignition	white	+	ignition harness
Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.
Third Ignition	N/A
Accessory	orange	+	ignition harness
Second Accessory	brown	+	ignition harness
Keysense	lt. green	-	ignition harness
Power Lock	use Directed module 456G
Notes: If Directed module 456G is not available, refer to DirectFax document 1601.
Power Unlock	see power lock
Lock Motor	gray		driver door module in door
Unlock Motor	tan		driver door module in door
Parking Lights+	brown	+	driver kick panel
Parking Lights-	gray/black	-	switch or BCM, brown plug pin B2
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Hazards	white	-	steering column
Turn Signal(L)	green	+	steering column
Turn Signal(R)	lt. green	+	steering column
Reverse Light	lt. green	+	BCM, black plug, pin F
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Door Trigger	see notes	-	see notes
Notes: The driver door trigger is gray/black at the driver door module in the door. The RF door trigger is BLACK/ white at the passenger door module in the door. The LR door trigger is lt. blue/black, pin A3, and the RR is lt. GREEN/ black, pin A2, they are in the purple plug at the BCM. Use all four wires and diode isolate each. The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Dome Supervision	gray/black	+	BCM, black plug, pin E
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Trunk/Hatch Pin	N/A
Hood Pin	N/A
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm	arms with lock
Factory Alarm Disarm	lt. green	-	driver door module in door
Disarm No Unlock	see factory alarm disarm
Tachometer	white	ac	instrument cluster or PCM
Notes: The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. The tach wire is in the green plug, pin 10. For tach can also go to any of the ignition coils or injectors and use the wire that is NOT pink, black, or brown.
Wait to start	N/A
Brake Wire	white	+	brake pedal switch
Parking Brake	lt. blue	-	switch or BCM, lt. blu plug, pin A7
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Horn Trigger	BLACK / YELLOW to black	-	column or BCM, gray plug, pin B9
Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
Memory Seat 1	red	+	driver door module in door
Memory Seat 2	pink	+	driver door module in door
Memory Seat 3	N/A	+

Immobilizer Bypass Module:	Required: Yes	Type: Passlock 2	Part #: 555L or 555T
Notes: The Passlock 2 wire colors are yellow, black (org/blk), and RED / white (not used).

wire diagrams for 04 park ave and avalanc - Last Post -- posted image.

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Back to Top

ka3vvv

Copper - Posts: 47

Joined: April 30, 2004

Location: United States

Posted: June 26, 2004 at 10:47 PM / IP Logged

Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.

would this be the same for a 2003 GMC YUKON.

I have my check engine light on never had this befor . But I also have a service 4 wheel light on. took to dealer for that it. It bad module in have a leak in the case. This happen befor check engine light.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

wire diagrams for 04 park ave and avalanc

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.