1995 c1500 and cliford rsx3.5

Hey fellas and gals,

I am going to try and install this alarm myself and was hoping for a little help if i could get it.  I understand most of the wiring components but i  have a few questions. The door trigger, the locks, and the illuminated entry. If i understand is the illuminated entry nly something to worry about in the newer vehicles with factory alarms? On the trigger what is the best way to wire it so it reaches all the doors?  With the door locks, btw it has keyless entry, do i need the supplied resistors and all of the wires on the 451m block? your help would be greatly appreciated. Mike

you only need the 451M if you have reverse polarity door locks in that vehicle, either way you wont need the supplied resistors....  the 3.5 has dual polarity DRL outputs, so you may not need the 451 at all.... check the vehicle and verify the door lock circuit in it.....

you dont need to hook up the domelight supervision circuit unless you want that feature, i rarely hook it up for customers, it's a silly feature.....