hi guys need to ask this...this is what i got 2 12" Kicker EX both rated @ 125WRms(ported), and my amp for each sub is 50Wrms...should i just use 1 sub and BRIDGE the amp to 100Wrms??

Which sound better?

Ok my sub is 4 Ohms and this is the info on my amp:

Amp

Max Power OutPut (4 Ohms)

Normal                         100 W x 2

Bridge                                      300 W x 1

 

Rated Power  Output (4 Ohms)

Normal                                     50 x 2 (20 Hz – 20 kHz less than  0.08 % THD)

Bridge                                      150 x 1(1 kHz 0.8 % THD)

 

Rated Power Output (2 Ohms)

Nomal                                      75 x 2 (1 kHz 0.8 % THD)

Now what is the best way to wire this??

Thanks sorri about the mess!

That is not at all readable.

I second the recommendation above...but bridging an amp will not produce the power you stated above.  That is, the ohm load would be different when each sub is wired in stereo to the amp, so combining them changes it.  And bridging an amp halves the ohm load.  Please post the impedance of each sub.  And the actual ratings of the amp as it is spec'd for the different loads.

My Kicker 12" sub is rated at 4 Ohms ( and i got 2 )

Amp

Max Power OutPut (4 Ohms)

Normal                         100 W x 2

Bridge                                      300 W x 1

 

Rated Power  Output (4 Ohms)

Normal                                     50 x 2 (20 Hz – 20 kHz less than  0.08 % THD)

Bridge                                      150 x 1(1 kHz 0.8 % THD)

 

Rated Power Output (2 Ohms)

Nomal                                      75 x 2 (1 kHz 0.8 % THD)

So can u tell me what is the best way to wire it???

Thanks :)

Amp

Rated Power  Output (4 Ohms)

Rated Power Output (2 Ohms)

Thanks sorri for all the trouble b4!