Pushbutton Switch for Starter

Yes

or you could omit the Relay and buy a push switch at the Auto parts store and a fuse holder.

Works great now. Thanks.

The next problem is that the door acutator are now not working. I have a Code Alarm Elite 2000 and look at the site's relay information and relay use with keyless entry with the 4-wire dual relays to see if the relays were bad. The ohms between 30 & 87A is 80 ish rang while the 86 to 85 is .02.

One of the locks is stuck in the open position (passenger door). There is no ignition kill and has the one sensor. Any thoughts?

The only thing I can tell you about that is.

Disconnect the hot and Ground from the Relay and Actuate it with 12v that you know are Good Like from another battery that is 12v. Test the Relay and see if it is good or not. Then trace the wires back to your original source of power until you find the bad part. Usually a fusable link.

For the push button for starter.. go under de steering and cut the starter wire.. "this is the wire you need to find" :) that's all :)

Chouby 8)