Need pin number diagram for a 02 liberty

Home / the12volt's Install Bay / Car Security and Convenience / Need pin number diagram for a 02 liberty (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

kerrys914

Member - Posts: 9

Joined: October 01, 2004

Location: United States

Posted: October 02, 2004 at 1:50 PM / IP Logged

Anyone have a pin number diagram for C1, C2, C3 and the BCM for a '02 liberty

Cheers

Audi 2002

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: October 02, 2004 at 3:12 PM / IP Logged

it would help to know what you are installing...........................

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

kerrys914

Member - Posts: 9

Joined: October 01, 2004

Location: United States

Posted: October 02, 2004 at 4:04 PM / IP Logged

I am installing a security/remote start system. I know what wire/pin I need to connect to. I just don't know the arrangment of the connectors.

Audi 2002

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: October 02, 2004 at 4:15 PM / IP Logged

are you asking for the car info????

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

kerrys914

Member - Posts: 9

Joined: October 01, 2004

Location: United States

Posted: October 02, 2004 at 4:35 PM / IP Logged

I am looking for a diagram that will tell me "pin" numbers in the C2, C2, or C3 connector on the fusepanel/BCM board.

I know which "pin" I need to connect to but the connector is not numbered. For example: where is "pin" nuber 14 on the C2 fuse connector .

This is car specific and I need the diagram for a 2002 Jeep Liberty.

Audi 2002

gus1

Gold - Posts: 1,013

Joined: October 15, 2003

Location: Canada

Posted: October 03, 2004 at 2:05 AM / IP Logged

Have you tried the dealer's service manual? Most multi pinned connecters are numbered somehow on either the wire side or pin side. Looking down the wire at the connector, you could try counting from left to right, and then veifying with a DMM that the wire in question is indeed functioning as it is described.

Gus

Wherever I go, that is where I end up......

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: October 03, 2004 at 9:50 AM / IP Logged

use the following info for your install.....you have to hook up to the any wires at the BCM, then look for the right color and meter the wire for the right polarity....

Make: Jeep

Model: Liberty

Year: 2002

Alarm

Constant 12 volts RED OR PINK/BLACK IGNITION SWITCH HARNESS

Ignition 12 volts RED / BLUE IGNITION SWITCH HARNESS

Starter YELLOW IGNITION SWITCH HARNESS

Dome Light YELLOW (-) DRIVERS KICK PANEL *

Trunk Pin Switch TAN/BLACK (-) AT BCM ON BACK OF JUNCTION BLOCK

Parking Lamp LT GREEN/ ORANGE (-) STEERING COLUMN HARNESS USE 1k OHM

Power Lock PINK/VIOLET AT BCM ON BACK OF ** #217

Power Unlock SINGLE WIRE SYSTEM JUNCTION BLOCK IN DRIVER KICK PANEL

#217 - See Single Wire Resister Door Lock Diagram. * Alt Door Trigger- TAN=Driver TAN/WHITE=Passenger Both (-) At BCM On Back Of Junction Block Diode Isolate ** Chassis Ground Thru 1.4K Ohm Resistor For Lock And A Chassis Ground Thru 425 Ohm Resistor For Unlock. MUST Use Relays!

Remote Start

Tach Signal BLACK ANY INJECTOR

Ignition #2 BLACK/ ORANGE IGNITION SWITCH HARNESS #239

Ignition #3

Accessory BLACK/ WHITE IGNITION SWITCH HARNESS

Neutral Safety NON GROUNDING TYPE

Brake Light WHITE/ TAN AT BRAKE PEDAL SWITCH

Reverse Light BROWN / GREEN(+) PIN #48 72 Pin GREY CONN IN DRIVER KICK PIN

Rear Window Defrost

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Need pin number diagram for a 02 liberty

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.