Toyota Tacoma 2004
Remote start / Security / GPS
Wire/Function Colour Location/Description Polarity
12 VOLTS White or WHITE/ red Ignition switch harness +
IGNITION BLACK / YELLOW Ignition switch harness +
IGNITION 2 BLACK/ red Ignition switch harness +
ACCESSORY Runs with ignition wire
STARTER Black Ignition switch harness +
TACH See notes*
FUEL INJECTOR Opposite from BLACK/ red At any injector on engine AC
LOCK BLACK/ blue In driver's kickpanel -
UNLOCK RED / yellow In driver's kickpanel -
DOORPIN SEE NOTES**
BRAKESWITCH GREEN / WHITE At switch above brake pedal +
PARKLIGHTS Green At bottom of fusepanel +
HAND BRAKE GREEN / WHITE At switch on handbrake lever -
HORN GREEN/ red At steering column -
CLUTCH SWITCH BLACK/ white At switch on top of clutch pedal TYPE 1
DRIVER WINDOW UP Blue / YELLOW At master window switch REV POL
DRIVER WINDOW DOWN Blue/green At master window switch REV POL
PASSENGER WINDOW UP RED / black At master window switch REV POL
PASSENGER WINDOW DOWN RED / green At master window switch REV POL
HEADLIGHTS RED / blue or RED / green At light switch harness -
REVERSE LIGHTS RED / black In driver's kickpanel +
DIMMER WHITE/ green At harness behind dimmer switch +
VSS WIRE GREEN/ orange*** At ECM behind glovebox***
KEY SENSE Lt.GREEN/ red Ignition switch -
Vehicle notes
* On the 2.4L and the 2.7L engine, there are 2 coils on the left front of the engine. Use the BLACK/ BLUE or BROWN / YELLOW for a 2 cylinder signal. On the 3.4L engine there is a coil per cylinder. Use the wire opposite from the BLACK/ RED at any of the coils. With any of the engines you can also find a BLACK tach reference at pin-15 of the 26-pin connector on the ECM behind the glovebox.
** GREEN (driver's door), GREEN / WHITE (passenger door), YELLOW /GREEN (rear doors). All 3 wires are found in a 22-pin connector on the front of the fusepanel under the dash. Isolate with 1N4001 diodes if connecting together.
*** The GREEN/ ORANGE vss wire is located on the ECM behind the glovebox. On the 2.4L and 2.7L, it's at pin-8 of the 22-pin connector. On the 3.4L, it's at pin-12 of the 28-pin connector.
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only.
--------------------------------------------------------------------------------
©2002 Autoland All rights reserved
Printed at: 10/5/2004 7:00:28 PM