2002 Plymouth Voager wiring
Welcome Guest :)
vanmanderf
Member -
Posts: 1
Joined: August 11, 2004
Posted: November 06, 2004 at 8:58 PM / IP Logged
i need a wiring diagram for my 2002 plymouth voager van
jr
Falcon 1
Copper -
Posts: 130
Joined: November 15, 2003
Location: Canada
Posted: November 06, 2004 at 11:06 PM / IP Logged
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | YELLOW (READ NOTEs BELOW) | IGNITION SWITCH HARNESS** |
Ignition #1: | | PINK/WHITE | IGNITION SWITCH HARNESS* |
Ignition #2: | | N/A | |
Ignition #3: | | SEE NOTE | *** |
Accessory: | | N/A | |
Brake Light: | | WHITE/ TAN | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | | |
Parking Lights: | | RED / BLACK (+) | AT GREEN PLUG NEAR FUSE PANEL |
Headlights: | | | |
OEM Alarm Disarm: | | VIOLET/LT. BLUE | AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE |
OEM Alarm Arm: | | | |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * Many Of These Vehicles Are Equipped With A Transponder (Even If The Key Is Black). Use Universal Alarm Bypass Module part # 2x402 where X can be any number. **A Second Start Wire (PURPLE / Brown) Needs a relay installed to provide a ground (-) through a 180 Ohm Resistor during crank in order to remote start the vehicle. The accessories of the vehicle may not function properly unless this relay is completely isolated from the unit by a second relay. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | RED | IGNITION SWITCH HARNESS (MAX 10 AMPS) |
Starter Kill: | | YELLOW (READ NOTEs BELOW) | IGNITION SWITCH HARNESS** |
Ignition +12 Volts: | | PINK/WHITE | IGNITION SWITCH HARNESS* |
Dome Lights/Superv: | | BLACK/ WHITE (-) | AT 4 PIN PLUG NEAR FUSE PANEL |
OEM Horn: | | GREEN/ BLACK (-) | STEERING COLUMN HARNESS |
Power Lock: | | PURPLE / GREEN | AT PLUG AT PCM ON FIREWALL **** |
Power Unlock: | | SAME WIRE AS POWER LOCK | |
Trunk Release: | | VIOLET/TAN | AT PLUG AT PCM ON FIREWALL DRIVER'S SIDE***** |
Alarm Input Wire: | | BLACK/ WHITE (-) | AT 4 PIN PLUG NEAR FUSE PANEL |
Notes: | | ****See Installation Note #211. Lock is negative trigger through a 5.3K (5300) ohm resistor. Unlock is negative through a 2.0K (2000) ohm resistor. *****Hatch release is negative through a 1.6K (1600) ohm resistor. |
Do it right the first time, only a doctor can bury his mistakes.
Follow the12volt.com
Thursday, September 12, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.