the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2004 infinity g35 coupe alarm wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
ksingh 
Copper - Posts: 62
Copper spacespace
Joined: November 16, 2004
Posted: December 04, 2004 at 4:22 PM / IP Logged  

hey what up guys i am doing an alarm in this vehicle tomorrow sunday and i would like to know if anyone has the wiring schematic on this vehicle and can post it i would appreciate it .  also please help me out with as much info as possible on this vehicle because its the first infinity i will be doing and i have it have it done by the end of the day no time for mistakes

thanks guys

Kenny
mxxmikexx 
Silver - Posts: 796
Silver spacespace
Joined: September 18, 2002
Location: United States
Posted: December 04, 2004 at 4:51 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - INFINITI / G35 COUPE / 2004 / Remote Start
[PRINT THIS PAGE]
12volts WHITE/ blue   +   ignition harness
Starter RED / white or WHITE/ red   +   ignition harness
Second Starter WHITE/ green   +   ignition harness
Ignition BLACK/ red   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory WHITE/ black   +   ignition harness
Second Accessory N/A       
Keysense BLACK/ pink   +   ignition harness
Power Lock yellow   -   driver door module in door
Notes: These are the driver door key cylinder wires. Meter the wires while turning the key in the driver door.
Power Unlock lt. blue   -   driver door module in door
Notes: These are the driver door key cylinder wires. Meter the wires while turning the key in the driver door. Unlock requires a double pulse.
Lock Motor purple   5wi 16 pin plug, pin 30 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Unlock Motor yellow   5wi 16 pin plug, pin 23 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Parking Lights+ RED / blue   +   driver kick, harness to rear
Parking Lights- N/A       
Hazards GREEN/ red   -   brown plug, pin 61 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Turn Signal(L) GREEN / WHITE   +   16 pin plug, pin 22 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Turn Signal(R) PURPLE / white   +   16 pin plug, pin 21 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Reverse Light PURPLE / orange   +   driver kick, harness to rear
Door Trigger yellow (L), pink (R)   -   white 12 pin plug at BCM
Notes: The driver door trigger is yellow in pin 14, and the passenger door is pink in pin 10. Use both wires and diode isolate each.
The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Dome Supervision comes on with unlock       
Trunk/Hatch Pin RED / white   -   12 pin plug, pin 18 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Hood Pin lt. GREEN/ black   -   pin switch under hood
Trunk/Hatch Release pink   -   brown plug, pin 76 at BCM
Notes: The BCM (Body Control Module) is in the driver kick panel, it has four white plugs and one brown plug.
Power Sliding Door N/A       
Factory Alarm Arm arms with lock       
Factory Alarm Disarm disarms with unlock       
Disarm No Unlock single pulse power unlock       
Tachometer NOT black or WHITE/ blue   ac   any ignition coil
Wait to start N/A       
Brake Wire pink/blue   +   brake pedal switch
Parking Brake lt. GREEN/ black   -   parking brake switch
Horn Trigger GREEN/ black   -   steering column
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U or 555U
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, November 9, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer