97 maxima alarm/remote start

I noticed that the trunk release and the trunk trigger are the same wire, I was told that a relay has to be used to interface with this conections. Can some one tell me how I can go about doing this? Do I just tap into the same wires for the trunk trigger and trunk release?  thanks.....

I just wanted to make sure, do both starter wires have to be used when remoter start, and also both accessory wires as well?  I was told that only one access wire is needed for remote start, if so, wil heat and air still work? thanks...

Up to me it is always better to power up every circuit in a car when remote starting( you will play it saffer)Even if only one accessory will be enough in that case the 2 starters are mandatory .. If you don't hook up the second start wire the vehicule will not start by cold time.

I see where that would confuse if looking at TECH soft. TRUNK/HATCH PIN|purple / YELLOW |-|drivers kick or BCM TRNK/HTCH RELEASE|purple / YELLOW |-|low drivers kick But in effect they want you to provide a 30 amp ground to this wire when doing trunk release. Set the relay up as a NEGATIVE trigger using the AUX output on your alarm system: Pin 86 to alarm output (-) pin 87 to ground pin 85 to 10 amp inline fuse then to constant power. pin 30 goes to the purple / YELLOW wire. 87a is not used. That should do it. Good luck with it. ALARMTEK.Robert Martin/Owner

ALARMTEK ONLINE

www.ALARMTEKONLINE.com