2005 Chevrolet Astro Van Alarm/Remote Start Wiring
Welcome Guest :)
westley69
Member -
Posts: 2
Joined: August 12, 2004
Location: United States
Posted: February 04, 2005 at 2:42 PM / IP Logged
please list a wiring diagram of the new chevrolet astro van 2005.
westley bruggeman
jandjav
Member -
Posts: 13
Joined: October 28, 2004
Posted: February 05, 2005 at 12:04 AM / IP Logged
MODEL | YEAR(S) |
ASTRO | 2000 -2005 |
KEY | T-HARNESS | IMMOBILIZER |
N/A | GM-1 | 791 BYPASS MODULE |
PART | COLOR | LOCATION | DIAGRAM |
12 VOLT CONSTANT | RED and RED / WHITE (+) | IGNITION SWITCH HARNESS | |
STARTER | YELLOW (+) | IGNITION SWITCH HARNESS | |
STARTER 2 | N/A | | |
IGNITION 1 | PINK (+) | IGNITION SWITCH HARNESS | |
IGNITION 2 | WHITE (+) | IGNITION SWITCH HARNESS | |
IGNITION 3 | N/A | | |
ACCESSORY /HEATER BLOWER 1 | ORANGE (+) | IGNITION SWITCH HARNESS | |
ACCESSORY /HEATER BLOWER 2 | BROWN (+) | IGNITION SWITCH HARNESS | |
KEYSENSE | N/A | | |
PARKING LIGHTS ( - ) | N/A | | |
PARKING LIGHTS ( + ) | BROWN (+) | IN DRIVERS KICK PANEL or BCM, LIGHT BLUE PLUG, PIN B 6 | |
POWER LOCK | LIGHT BLUE | IN DRIVER KICK PANEL (TYPE A) | |
POWER UNLOCK | WHITE | IN DRIVERS KICK PANEL (TYPE A) | |
DOOR TRIGGER | See NOTE * | @ BCM above CLIMATE CONTROLS | 26500_ASTRO_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf |
DOMELIGHT SUPERVISION | GREY/BLACK (-) | @ RELAY above DIAGNOSTIC PLUG | |
TRUNK RELEASE | LIGHT BLUE (-) | @ RELAY above DIAGNOSTIC PLUG | |
SLIDING POWER DOOR | N/A | | |
HORN | BLACK (-) | @ STEERING COLUMN HARNESS or BCM, BROWN PLUG, PIN A 9 | |
TACH | WHITE | @ PCM, GREEN PLUG PIN 26 See NOTE ** | |
WAIT TO START LIGHT | N/A | | |
BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL | |
FACTORY ALARM DISARM | N/A | | |
ANTI-THEFT | YELLOW and ORANGE / BLACK | GM's PASSLOCK 2 | |
EXTRA INFORMATION |
NOTE * the DRIVERS DOOR is a BLUE (-) PURPLE Plug, Pin B4, the PASSENGERS DOOR is a ORANGE (-) PURPLE Plug, Pin B2 and the SLIDING DOOR is a PINK (-) LIGHT BLUE Plug, Pin B10, the REAR DOOR is a YELLOW (-) LIGHT BLUE Plug, Pin B11. When connecting to an Alarm System use all 4 wires and Diode isolate See DIAGRAM. NOTE ** the PCM is located BELOW the BATTERY under the hood. NOTE *** the BCM is located above the CLIMATE CONTROLS in the CENTER of the DASH. |
LINK 1 | LINK TEXT 1 | LINK 2 | LINK TEXT 2 |
| | | |
Follow the12volt.com
Tuesday, January 21, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.