96 Toyota Landcruiser

Does anyone know what type of door looks come with a 96 toyaota landcrusier? Positive, negative, reverse polarity, etc. My alarm came with diodes that need to be positioned a certain depending on positive or negative. Also, I found information in this site which identifies the wire colors and generally where to look for them but I have a question about the door lock wiring. The diagram that came with the alarm shows the connection between the lock switch and the "factory lock relay". Is this relay inside the door? Thanks!

12volts	black - WHITE/ red	+	ignition harness
Starter	BLACK/ white	+	ignition harness
Second Starter
Ignition	BLACK / YELLOW	+	ignition harness
Second Ignition	blk/grn or blk/red	+	ignition harness
Third Ignition
Accessory	blue/red	+	ignition harness
Second Accessory
Keysense
Power Lock	blue/black	-	driver door harness in kick
Power Unlock	blu/yel & blu/org	-	driver door harness in kick
Notes: Both wires must be used and diode isolated.
Lock Motor
Unlock Motor
Parking Lights+	green		drivers kick
Parking Lights-	RED / black		steering column
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	RED / white	-	back of cluster
Notes: May also be found RED / blue or white in top of the fuse box in a harness from domelight. Use RED / blue for dome supervision.
Dome Supervision
Trunk/Hatch Pin	tied with door
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	black	ac	igniter or check conn
Notes: Check connector is on the passenger side firewall near wiper motor. Igniter is by brake master cylinder.
Wait to start
Brake Wire	GREEN / WHITE	+	brake switch
Parking Brake
Horn Trigger	GREEN/ blue	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: No	Type: N/A	Part #: N/A
Notes: N/A

and you can eiher get em from the door boot... or the door... i havnt done one of these in a long time so i would say just go in the door... boots can be a pain in the ass to do stuff and sometimes its easier to do a lil more work  ;)

Thanks for the response but I guess I am still a bit confused. It's probably me just not understanding the chart I guess. I am trying to understand a few specfic things: 1. Is the door type type for this vehicle is a positive, negative or reverse polarity type? 2. Do I need to install the diodes for this vehicle? 3. Is is important to install the keyless entry wires between the lock switch and the lock relay like the instruction show in the car alarm instal manual??

1. Negative 2. Yes, TOYOTA, LAND CRUISER, 1996, Power Unlock Both wires must be used and diode isolated. This will prevent any feedback to the alarm unit. Connect the diode with Cathode (side with the stripe) to the alarm unit. 3. NO, since every car is different. Look at the wiring schematic for the car you are working with. Test the wire with a digital multimemter. If they are correct. Wire it up. As for your car. They are the following: Power Lock blue/black    -   driver door harness in kick      Power Unlock blu/yel & blu/org    -   driver door harness in kick Be careful whose advice you buy, but be patient with those who supply it.

Thank you! This is exactly what I needed to understand.